PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. MINOR TRIMMING
MAY BE REQUIRED.
2. Start installation under the front of the vehicle, (Figure 1). Remove the two factory bolts
holding the driver side tow hook in place and remove the tow hook from the vehicle. NOTE:
Tow hooks cannot be reinstalled with this Grille Guard. Apply a protective layer of removable
tape, (masking tape for example), to the inside of the inlets in the plastic bumper for the tow
hook, (Figure 2).
3. Select the driver side frame Mounting Bracket. From behind the bumper, insert the Bracket
through the inlet for the tow hook, (Figure 3 & 4). Line up the (2) holes in the Bracket with the
holes for the tow hook hardware. Bolt the Bracket to the frame with (2) 12mm x 35mm Hex
Bolts, (4) 12mm Flat Washers, (2) 12mm Lock Washers and (2) 12mm Hex Nuts. Remove the
protective tape. Do not tighten hardware at this time.
4. Repeat Steps 2 - 3 for passenger side Mounting Bracket installation.
5. Open the hood and using a flat screwdriver, remove the clips holding the plastic cover in place
on top of the radiator, between the radiator and the grille insert. Gently pry up the center button
to release, then remove entire clip.
6. Remove the grille insert. NOTE: Use a pair of “needle nose” pliers to squeeze the grille
mounting clips to release, (Figure 5). Once all clips have been released and any other
hardware removed, gently pull the grill insert forward from the vehicle.
Commentaires sur ces manuels