PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting at the passenger side-front of the vehicle, locate the round and rectangular openings
in the inner body panel. NOTE: Mounting holes may be covered with rubber plugs and/or
sealing tape. Remove to uncover mounting locations. Insert (2) 10mm Clip Nuts (with the nut
portion to the inside) into the rectangular opening and line up the threaded nut with the factory
round holes, (Figure 1). Next, partially thread (1) 11mm Plastic Retainer onto (1) 12mm Bolt
Plate, (Figure 2), and insert the Bolt Plate into the large round hole. Once inserted, thread the
Plastic Retainer onto the threaded end of the Bolt Plate until it is flush against the body panel.
NOTE: When properly installed, the Plastic Retainer is designed to prevent the Bolt Plate from
falling into the body cavity during Bracket installation.
Commentaires sur ces manuels